Expansion Module Startup Initialization - Nortel 2033 Installation And Operation Manual

Page 460 of 600

Expansion Module startup initialization

553-3001-368 Standard 20.00
Expansion Module for IP Phone 1100 Series
5 Adjust the height of the IP Phone tilt adjustment to a comfortable viewing
angle. Then adjust each of the Expansion Module footstands so they are
flush to the desk surface. Turn the wheel on the back right side of the
Expansion Module to the right (if viewed from the front) to tighten the
Expansion Module.
CAUTION
Do not over tighten the wheel on the Expansion Module.
6 Connect power to the IP Phone. The Expansion Module powers up.
Note: The Expansion Module uses the electrical connection of the
IP Phone for power. It does not have its own power source.
After the Expansion Module is installed and powered up on the IP Phone, the
Expansion Module initializes.
December 2006
End of Procedure