Nortel 2033 Installation And Operation Manual page 562

Page 562 of 600
553-3001-368 Standard 20.00
Appendix G: Bluetooth wireless technology
4 Start the TFTP Server. The TFTP Server must be running on the network
when the IP Phone 1140E powers up to retrieve the Bluetooth wireless
technology administrative control. After you put the 1140e.cfg and the
device config file in the TFTP Server directory, ensure the TFTP Server is
running then reboot the IP Phone 1140E. For information about TFTP
Server configuration, refer to Appendix H "TFTP Server" on
Once the IP Phone 1140E retrieves the setting when the IP Phone 1140E
restarts, it is saved in persistent memory. If the Enable BT setting is set to
Auto, then the received value is acted on and Bluetooth wireless
technology is either enabled or disabled on the IP Phone 1140E. If the
Device Config file with the Enable BT setting is not received for any
reason and the Enable Bluetooth mode is set to Auto, then the phone
uses the last value received (retrieved from persistent memory).
If administrative control is not retrieved, the previously received value is
used. If no value has ever been retrieved, then Bluetooth wireless
technology is disabled by default.
If the IP Phone 1140E successfully retrieves the administrative control
and enables Bluetooth wireless technology, 3. Bluetooth Setup appears
in the Preferences menu.
5 Configure the IP Phone 1140E with a TFTP Server IP address so the
IP Phone can access the TFTP Server.
6 Press the Services key twice.
7 Press 3 on the dialpad to access the Network Configuration menu or
use the Up/Down navigation keys to scroll and highlight the Network
Configuration option. Press Enter.
8 Enter the TFTP IP address in the TFTP IP field.
9 Press the Apply&Reset soft key.
December 2006
End of Procedure
page 571.