Nortel 2033 Installation And Operation Manual page 92

Page 92 of 600 Nortel IP Phone 2002
553-3001-368 Standard 20.00
For more information on EAP, refer to Appendix C "802.1x Port-based
network access control" on
2 At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for
No).
For more information about LLDP, refer to Appendix D "802.1ab Link
Layer Discovery Protocol" on
3 At the prompt DHCP Yes/No?, enter 0-N (0 for No).
By default, Full DHCP is configured on the IP Phone 2002. Depending on
the configuration requirements, you can change the IP Phone 2002
configuration to allow the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
Note: A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, refer to Converging the Data Network with VoIP
(553-3001-160).
4 Enter the following information:
Screen prompt
set IP
net msk
def gw
December 2006
page 493.
page 495.
Description
A valid IP Phone 2002 IP address.
A subnet mask.
The default Gateway for the IP Phone 2002 on
the LAN segment to which it is connected.