Nortel 2033 Installation And Operation Manual page 396

Page 396 of 600
553-3001-368 Standard 20.00
Nortel IP Phone 1140E
The method to upgrade the firmware depends on the following Call Server
software:
• For Succession Release 3.0 or CS 1000 Release 4.0, the TFTP
Server is required to download the current firmware. Enter the TFTP
Server IP address at the prompt.
• For CS 1000 Release 4.5 and later, use either a TFTP Server to
upgrade the firmware (at the prompt accept the default entry of
0.0.0.0), or UFTP to download the current firmware.
For further information about TFTP Server configuration, see Appendix H
"TFTP Server" on
For Succession Release 3.0 and CS 1000 Release 4.0, the IP Phone
2007 searches for the TFTP Server for firmware upgrade. If the file name
specified in i2007.cfg is not the same as the current firmware, the IP
Phone downloads the file and upgrades the firmware. This takes several
minutes. When the upgrade is complete, the IP Phone 2007 reboots.
Note: The Enhanced UNIStim firmware download is only supported on
CS 1000 Release 4.5 or later.The Enhanced UNIStim firmware download
feature for IP Phones provides an improved method of delivering new
firmware to IP Phones. For further information on Enhanced UNIStim
Firmware Download, refer to IP Line: Description, Installation, and
Operation (553-3001-365).
The IP Phone 1140E searches for the connect server.
The IP Phone 1140E registers with the Terminal Proxy Server (TPS) and,
if needed, begins the firmware download. This takes several minutes.
When download is complete, the IP Phone 1140E resets.
The current Call Server date and time appear on the top line of the display
when the configuration is complete. Self-labeling keys also appear.
44 Check for dial tone and the correct DN on the display.
45 (Optional) Customize the feature keys as required. For more information,
see For more information, see Software Input/Output: Administration
(553-3001-311) and the IP Phone 1140E User Guide.
December 2006
page 571.
End of Procedure