Nortel 2033 Installation And Operation Manual page 347

Procedure 59
Installing the IP Phone 1120E
Timing information
There are approximately 45 s between plugging in the IP Phone 1120E
power adapter and the appearance of the text Nortel. When you see the
text Nortel on the phone, you have 1 s to respond by pressing the 4 soft
keys at the bottom of the display in sequence from left to right, one at a
time. If you miss the 1-s response time, the IP Phone 1120E attempts to
locate the connect server. You can begin the power-up sequence again,
or you can double-press the Services key to open the Local diagnostic
utilities to access the IP Phone settings. See Appendix E "IP Phone
diagnostic utilities" on
1 When the Nortel logo appears in the middle of the display, immediately
press the four soft keys at the bottom of the display in sequence from left
to right. The 3. Network Configuration menu opens.
Note: You can press the Apply&Reset soft key to save the following
settings and to reset the IP Phone. You can press the Exit soft key exit
the menu to exit the menu without saving any changes and return to the
3. Network Configuration menu.
When the 3. Network Configuration menu opens, the Enable 802.1x
(EAP) check box is highlighted.
2 Press the Enter key to toggle this item on and off. A check mark appears
to indicate the item is active.
If 802.1x Authentication is enabled, press the Enter key to start the edit
mode. Use the keypad to fill in the following information:
• Device ID
• Password
• Retype password
For further information about EAP, refer to Appendix C "802.1x
Port-based network access control" on
Note: If you do not enable 802.1x Authentication, you will not be
prompted to enter Device ID and Password.
Nortel IP Phone 1120E
IMPORTANT!
page 497.
page
IP Phones Description, Installation, and Operation
Page 347 of 600
493.