Nortel 2033 Installation And Operation Manual page 308

Page 308 of 600
553-3001-368 Standard 20.00
Nortel IP Audio Conference Phone 2033
By default, Full DHCP is configured on the IP Audio Conference Phone
2033. Depending on the configuration requirements, you can change the
IP Audio Conference Phone 2033 configuration to allow the following
IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, refer to Converging the Data Network with VoIP
(553-3001-160).
2 At the prompt, Cached IP?, select 0 (0-No, default) to conform to the
DHCP standard and to obtain an IP address from the DHCP server. Only
select 1 (1 for Yes) to force the IP Phone to start with a cached IP address
in the event that the IP Phone cannot connect to the DHCP server and
obtain an IP address.
3 Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are retrieved
from the DHCP server:
— a valid IP Audio Conference Phone 2033 IP address
— a subnet mask
— the default Gateway for the IP Audio Conference
Phone 2033 on the LAN segment to which it is connected
— the S1IP. The primary CS 1000 node IP address of the IP
Phone.
— the S1 action
— the S1 retry count. This is the number of times the IP Audio
Conference Phone 2033 attempts to connect to the server
— the S2 IP. The secondary CS 1000 node IP address of the IP
Phone.
— the S2 action
December 2006