Replacing An Ip Phone 1150E; Removing An Ip Phone 1150E From Service - Nortel 2033 Installation And Operation Manual

Replacing an IP Phone 1150E

Removing an IP Phone 1150E from service

Two IP Phones cannot share the same TN. You must remove the
IP Phone 1150E that is currently using the TN.
Procedure 77
Replacing an IP Phone 1150E
1 Obtain the node and TN information of the phone you want to replace.
2 Disconnect the IP Phone 1150E that you want to replace.
3 Follow Procedure 72 on
IP Phone 1150E.
4 Enter the same TN and Node Number as the IP Phone 1150E you
replaced. The system associates the new IP Phone 1150E with the
existing TN.
Procedure 78
Removing an IP Phone 1150E from service
1 Disconnect the IP Phone 1150E from the network or turn the power off.
Note: The service to the PC is disconnected as well if the PC is
connected to the IP Phone 1150E.
If the IP Phone 1150E was automatically configured, the DHCP lease
expires and the IP address returns to the available pool.
2 In LD 11, enter OUT at the TN prompt.
Nortel IP Phone 1150E
IMPORTANT!
page 428 to install and configure the
End of Procedure
End of Procedure
IP Phones Description, Installation, and Operation
Page 449 of 600