Introduction; Description - Nortel 2033 Installation And Operation Manual

Page 112 of 600

Introduction

Description

553-3001-368 Standard 20.00
Nortel IP Phone 2004
This section explains how to install and maintain the IP Phone 2004. For
information on using the IP Phone 2004, see the IP Phone 2004 User Guide.
This section contains the following procedures:
• Procedure 17, "Configuring the IP Phone 2004" on
• Procedure 18, "Installing the IP Phone 2004 for the first time using
manual configuration" on
• Procedure 19, "Installing an IP Phone 2004 for the first time using
DHCP" on page
• Procedure 20,"'Enabling Full Duplex mode" on
• Procedure 21, "Checking Ethernet Statistics" on
• Procedure 22, "Changing the TN of an existing IP Phone 2004" on
page 146.
• Procedure 23, "Replacing an IP Phone 2004" on
• Procedure 24, "Removing an IP Phone 2004 from service" on
Note: After an IP Phone has been installed and configured, if power is to
the phone is interrupted, re-entry of the IP parameters, Node Number,
TN, or re-acquisition of firmware is not required.
The IP Phone 2004 uses the customer IP data network to communicate with
the Communication Server 1000. The IP Phone 2004 translates voice into
data packets for transport using Internet Protocol. A Dynamic Host
Configuration Protocol (DHCP) server can be used to provide information
that enables the IP Phone 2004 network connection, and connection to the
Communication Server 1000.
Figure 7 on page 113
December 2006
page 130.
137.
shows the IP Phone 2004.
page 125.
page 144.
page 145.
page 147.
page 148.