Nortel 2033 Installation And Operation Manual page 53

Figure 3
IP Phone 2001 Ethernet network interface connections
7 Power the IP Phone 2001 using either the Power over Ethernet or an AC
power transformer (local power). If you are using local power, plug the AC
power transformer into the nearest power outlet. Make sure you use the
correct AC power transformer is used. The voltage rating of the
transformer must match the wall outlet voltage. Refer to Table 4 on
page 49.
Note: The IP Phone 2001 supports both AC power and Power over LAN
options, including IEEE 802.3af Power Classification 2. To use Power
over Ethernet, where power is delivered over the CAT5 cable, the LAN
must support Power over Ethernet, and an AC adapter is not required. To
use local AC power, the optional AC adapter can be ordered separately.
8 Use Procedure 2 on
using manual configuration, or use Procedure 3 on
IP Phone 2001 for the first time using DHCP.
Nortel IP Phone 2001
page 55 to install the IP Phone 2001 for the first time
End of Procedure
IP Phones Description, Installation, and Operation
Page 53 of 600
page 61 to install the