Nortel 2033 Installation And Operation Manual page 306

Page 306 of 600
553-3001-368 Standard 20.00
Nortel IP Audio Conference Phone 2033
firmware, the IP Phone downloads the file and upgrades the firmware.
This takes several minutes. When the upgrade is complete, the IP Phone
reboots. For further information about TFTP Server configuration, see
Appendix H "TFTP Server" on
The IP Audio Conference Phone 2033 can support a primary (S1) and
secondary (S2) connect server. If you require IP Phones to register on
multiple nodes, refer to IP Line: Description, Installation, and Operation
(553-3001-365).
The IP Audio Conference Phone 2033 searches for the connect server.
When the connection is complete, proceed with Step 4.
4 Enter the following information:
Screen prompt
Password
Node
TN
Note: Select the Shift soft key labeled (>>) and press Clear to edit the TN
field. The IP Audio Conference Phone 2033 by default will place you in the
units field of the TN. You can not use backspace to move to the loop, shelf
or card fields.
The IP Audio Conference Phone 2033 registers with the Terminal Proxy
Server (TPS) and, if needed, begins the firmware download. This takes
several minutes. When the download is complete, the IP Audio
Conference Phone 2033 resets.
Note: The Enhanced UNIStim Firmware Download feature for IP Phones
provides an improved method of delivering new firmware to IP Phones.
For further information on Enhanced UNIStim Firmware Download, refer
to IP Line: Description, Installation, and Operation (553-3001-365).
The current system date and time appear on the top line of the display
when the configuration is complete. Self-labeling keys also appear.
5 Check for dial tone and the correct DN above the display.
December 2006
page 571.
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been configured
in your system.
The node ID.
The TN or VTN.