Nortel 2033 Installation And Operation Manual page 386

Page 386 of 600
553-3001-368 Standard 20.00
Nortel IP Phone 1140E
lower screws. When the lower screws are snug, install the phone on
the mounting screws, and then tighten the top screws.
• Method B: Attach the 15 cm (6 inch) CAT5e cable, position the stand
over the mounting rivets, and slide the phone down the wall so that
the rivets fit into the slots on the stand.
11 Replace the stand cover. Ensure that all cables are neatly routed and
press the stand cover into place until you hear a click.
12 Put the phone in the wall-mount position (optional). If you wall-mount the
phone, put it in the wall-mount position by holding the Tilt Lever and press
the phone towards the base until the phone is parallel with the base.
Release the Tilt Lever and continue to push the phone towards the base
until you hare an audible click. Ensure the phone is securely locked in to
position.
December 2006