Nortel 2033 Installation And Operation Manual page 131

3 At the prompt DHCP Yes/No?, enter 0-N (0 for No).
By default, Full DHCP is configured on the IP Phone 2004. Depending on
the configuration requirements, you can change the IP Phone 2004
configuration to allow the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
Note: A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, refer to Converging the Data Network with VoIP
(553-3001-160).
4 Enter the following information:
Screen prompt
set IP
net msk
def gw
Nortel IP Phone 2004
Description
a valid IP Phone 2004 IP address
a subnet mask
the default Gateway for the IP Phone 2004 on
the LAN segment to which it is connected
IP Phones Description, Installation, and Operation
Page 131 of 600