62.
CAUTION: Do not scratch cylinder walls or crankshaft journals with the connecting
rod.
NOTE: Before removing pistons, inspect the top of the cylinder bores. If necessary, remove the
ridge or carbon deposits from each cylinder using a cylinder ridge reamer following the
manufacturer's instructions.
Remove the piston removing pistons number 1 and 6 through the top of the cylinder block.
63. Repeat the previous two steps to remove the remaining pistons, rotating the crankshaft 90
degrees between piston pairs 3 and 5, 4 and 7, 2 and 8.
64. Remove the piston rings.