Turning On Power - Ikegami Editcam 3 DNS-33W Operation Manual

4.2.4 Rear Side of the Camera
MON
Switch Name
MIC ATT switch OFF
AUDIO SELECT LINE
switch
MIC
+48V ON : When connecting a microphone
4.2.5 Viewfinder
Switch Name
TALLY switch
ZEBRA switch
LINE MIC +48V LINE MIC +48V
ATT
-20dB OFF
Switch Position
: When line-inputting the audio
signal to the AUDIO IN CH1/CH2
connectors
: When connecting a microphone to
the AUDIO IN CH1/CH2
connectors
dedicated for phantom powering to
the AUDIO IN CH1/CH2
connectors
Switch Position
HIGH or LOW
ON
DNS-33W 0503 VOL1 (E)

4.3 Turning ON Power

There are two types of power supplies. One is the supply
from the AC pack and another is from the battery pack. The
way to turn ON the power is common to the two types. Turn
ON the power using the following procedures.
1. Turn ON the POWER switches of external system such
as AC pack, monitor, and remote controller.
2. Turn ON the POWER switch of the camera.
When the power is turned ON normally, the string
"BOOTING!!" is displayed on the VF screen. Then, the
four LEDs (AUDIO LED) on the right side of the camera
light up in orange.
After the camera is powered on normally, the LEDs once
turn off. Then, the color LCD on the right side of the camera
displays the logo "Ikegami" and the Status screen.
When an FP2 has been loaded in the camera, the logo
"Ikegami" is displayed and the disk is recognized
automatically (recognition requires a few seconds).
Turning OFF Power
Turn OFF the power switch.
A few seconds are required to complete the shutdown of the
camera. When the camera is to be restarted, the power must
be turned on 10 seconds or more after powering off.
4. OPERATION
DNS-33W
4 - 3