Status Displays; Warning Displays - Ikegami Editcam 3 DNS-33W Operation Manual

Character Display

Status displays

EX RETRO 00:00:00:00
A: 3.2K B:3.2K
P.FUNK BLK STR + 7% OFF
+ 6dB
B
1A

Warning displays

NG
AWB/ABB displays
AWB Ach
OK
4.3K
Notice
A correct F value is not displayed for the B3 lens when the IRIS OPERATION SELECT switch of the lens is set
to "M" (Manual). This is due to the specification of the lens and not indicative of a failure.
Lens extender operation display
Special recording operating mode display
Displays operating mode during the special recording.
During retro loop record: RETRO
During time lapse record : T.LPS
= |
S#-
0001
Position mark
00:00:00
Clip number
Clip length
Time code
AWB color temperature
This color temperature has been stored in AWB memory channel. It appears while
90
the VF CHARA button is pressed. The channel selected by the AWB select switch
flashes.
12.0 F16 1/100
Remaining disk amount indicator
Displays remaining FP2 disk amount time.
When remaining amount is more than 91 minutes:
When remaining amount is less than 90 minutes:
Shutter speed / Super-V mode
Lens F value (See Notice).
+F : IRIS+ CORR ON, +F : IRIS++ CORR ON
P.FUNC
Function assigned to the P.FUNC switch is displayed with its status.
Battery voltage/remaining charge
The present voltage is indicated when the battery voltage has dropped below the
setting. When the Anton Bauer intelligent battery is used, the present voltage is
indicated when the remaining charge has dropped below the setting.
The voltage setting indicating warnings and the remaining charge setting can be
changed by "POWER MENU" in the menu of the recorder section.
AUDIO level indicator
Indicates the input level of audio channels selected by a MONITOR AUDIO SELECT
switch located on the right side of the camera. Input level for CH1 or CH3 is indicated
in the upper bar, and for CH2 or CH4 is indicated in the lower bar.
GAIN UP value
AWB MEMORY set
A: Ach, B: Bch, 0: OFF
Priority right of filter control
Indicates whether the remote controller has the priority right to control the ECC filter.
* : Being controlled by the remote controller
ND, ECC Filter position
ND
ECC
Camera warning displays
Displays warning message of camera.
RF warning displays
Displays warnings when a wireless receiver supporting RF warning function is
connected with and the received radio wave level is low.
Auto function now being executed
"AWB Ach", "AWB Bch", "ABB", or "A.BLK SHADE"
Execution result
"OK"
"NG"
"STOP"
"LEVEL OVER"
"LEVEL UNDER"
"CHG FILTER"
"COLOR TEMP. HIGH" : Appears when color temperature of the subject is too high.
"COLOR TEMP. LOW"
AWB color temperature
The color temperature is indicated here upon completion of AWB.
DNS-33W 0503 VOL1 (E)
2. NAME AND FUNCTION
+
1 2 3
100% 25% 6.2% 1.6%
A B C
3200K 4300K 6300K 8000K
: Appears when the function has been completed.
: Appears when the function was not completed.
: Appears when the execution of the function was
discontinued.
: Appears when the input signal level is too high.
: Appears when the input signal level is too low.
: Appears when color temperature of the subject is too low.
>90
remaining time (Unit: minutes)
4
D
2 - 17
DNS-33W