Ikegami Editcam 3 DNS-33W Operation Manual page 133

[Camera Front Side]
Switch
SHUTT/SUP-V switch
Camera Front Side
ON AWB
OFF ABB
SHUTT/SUP-V
MENU
AUDIO OUT
VTR
[Viewfinder]
Switch
TALLY switch
ZEBRA switch
REAR TALLY switch
VF Front Side
ZEBRA Switch
Turning POWER ON
Turn ON the power of the camera and ensure that a normal
color-bar signal is output.
[When AC Pack is Used]
1. Connect the AC pack to the camera and turn ON the
POWER switch of the AC pack.
2. Turn ON the POWER switch of the camera.
3. Check that a normal color-bar signal is output on the VF
(monitor) screen.
[When Battery Pack is Used]
1. Attach the battery pack to the camera.
2. Turn ON the POWER switch of the camera.
3. Check that a normal color-bar signal is output on the VF
(monitor) screen.
7. TROUBLE SHOOTING AND MAINTENANCE
Position
OFF
SHUTT/SUP-V Switch
ON
OFF
SHUTT/SUP-V
Position
HIGH or LOW
ON
ON
REAR TALLY Switch
TALLY Switch
DNS-33W 0503 VOL1 (E)
7.2.2 Inspecting the Viewfinder
Inspect following items before shooting to check if the VF
works normally.
1. Adjust the VF position.
For details, refer to "3.4 Mounting the Viewfinder", "
Adjusting the Angle and Position".
2. Check that color bars appear in the viewfinder, and then
adjust the BRIGHTNESS knob, CONTRAST knob, and
PEAKING knob in such a way that the color bars appear
most clearly.
VF Front Side
PEAKING Knob
CONTRAST Knob
3. Set the OUTPUT SELECT switch to "CAM", switch the
ND FILTER knob to 1 to 2 to 3 to 4. Also, switch the
ECC FILTER SELECT button to A to B to C to D.
During this procedure, check that the character display of
the filter position switches in the VF as the filter position.
The + and – buttons must be pressed and held (for
approximately 0.5 seconds or more) only for the first time
in order to prevent accidental operation.
Camera Right Side
ND FILTER
Knob
AUDIO
POWER
VF
CHARA
ND ECC
4 1.6% D 8000K ECC P.FUNC
36.2% +
C 6300K
22.5% B 4300K
11.0% A 3 20K
FIL
-
HEAD
HYPER GAIN
4. Point the camera at a chart or other subject, turn the
focus ring to bring the subject into focus.
Check that the proper image appears on the VF.
BRIGHTNESS Knob
LIGHT
PANEL
TCG
33W
DNS-
ECC FILTER SELECT Button
DNS-33W
7 - 3