Connecting A Monitor - Ikegami Editcam 3 DNS-33W Operation Manual

3 - 10 3. INSTALLATION AND CONNECTION
Disconnecting the Battery Pack
This section explains how to disconnect the battery from the
camera.
1. While pressing down the button located on the top of the
battery pack, slide the battery upward to disconnect the
battery pack.

3.7 Connecting a Monitor

The camera has two connectors to output various video
signals. Following show the video signals from each
connector.
• MON OUT connector
Outputs the video signal (ENC, Y, R, G, B, R+G+B) set
in the camera setting mode (menu) or by the monitor
screen. During playback, the ENC signal of the playback
images is output.
• VIDEO OUT connector
Outputs the video signal of the camera (CAM) or color
bar signal (BARS) in accordance with the OUTPUT
SELECT switch position on the right side. During
playback, the ENC signal of the playback images is
output.
DNS-33W
Battery Release Button
DNS-33W 0503 VOL1 (E)
3.7.1 Connection through MONITOR OUT Connector
This section explains how to connect the camera and the PM
(picture monitor)/WFM (waveform monitor) through the
MONITOR OUT connector.
1. Connect MON OUT connector at the rear of the camera
and the monitors with a coaxial cable.
Camera Rear Side
COAX Cable
75Ω Terminal
VIDEO IN
MON
MON OUT Connector
PM
WFM