Ikegami Editcam 3 DNS-33W Operation Manual page 107

6. Create a lens file of the optional lens.
6-1. Remove the normal lens, and attach the optional lens
to the camera.
Go on to next step without removing the normal lens
when creating a lens file for the normal lens.
6-2. Set "FILE" setting to "ON".
6-3. Select a lens number from 1 to 8 in "NUMBER".
6-4. Turn the lens extender OFF.
6-5. Refer to step 5-3 and executed the auto white shading
function.
When auto white shading is executed, a lens file that
corresponds to the lens number is created.
6-6. In the case of a lens with extender, set the extender
setting to ON, then create a lens file in the same
manner as the previous step.
LENS SELECT
FILE
NUMBER
NAME
FILE SET
(AWB SW → A.WHT SHADE)
A.WHT SHADE
7. When creating the lens files of other lenses without break,
repeat the step 6 for the number of files to be created.
Notice
• If a new file is created with the same file number
as an existing file, the data will be overwritten and
the old data will be lost.
• Right after the auto white shading is completed,
the previous settings adjusted automatically till
then will be cleared. This is because the lens file
is stored in the internal memory of the camera. It
is not a malfunction.
8. After the lens file is created, turn off the "FILE SET".
Then, turn off the S2 switch on the MPU module for data
protection.
Notice
• When the power of the camera is turned off, the
"FILE SET" turns to "OFF".
• Before the lens file is created, prepare all the
lenses in use. Then, create files under the same
condition all at one time. If the condition are
changed, the setting can't be accurate. Lens file
ON
NO.1
( )
ON
OK
DNS-33W 0503 VOL1 (E)
5. SETTINGS AND ADJUSTMENT OF CAMERA
memorizes the difference in level between lenses.
If lighting and a chart are changed, it isn't realized
whether it is the error of the lighting and chart or
if it is the error of the lens.
• It is suggested to give a name to the LENS No.
in accordance with lens type.
• At shipment, the revision data by the factory
normal lens is registered in LENS No.1. Create a
lens file when using a new lens.
NAME (Inputs the name for lens files)
The lens files can be named by each number. By naming a
lens file after the model name, etc., the correspondence
between the lens number and the lens will be easier to
recognize.
1. Select a lens number of the lens file to name in
"NUMBER".
2. Select "NAME" and press the SET button.
The flashing cursor moves and the screen switches to
character input mode.
3. Select the necessary character using the rotary pulse
switch, and then press the SET button to confirm the
selected character one by one in the parenthesis.
4. When all the characters in the parenthesis are set, the
character input mode ends and the new file name is set.
If the file name is less than 12 characters long, be sure
to input blank spaces in the remaining fields. The
character input mode does not end unless there are 12
characters confirmed as the file name. Rotating the rotary
pulse switch scrolls through the characters as shown in
the figure below.
Rotating the rotary pulse switch UP/DOWN will scroll
*
through the characters in the following directions.
represents a blank space.
ABCDEFGHIJKLMN
LENS SELECT
FILE ON
NUMBER NO.1
NAME ( )
FILE SET OFF
U P
OPQRSTUVWXYZ !#$...{}"
DOWN
5 - 33
0123456789
DNS-33W