Preparations Before Shooting; Power On/Off - Ikegami Editcam 3 DNS-33W Operation Manual

Preparations before Shooting

Power ON/OFF

Turning On Power
Turn ON the POWER switch of the camera to turn the power of the camera on.
When the power is turned ON normally, the string "BOOTING!!" is displayed on the viewfinder (hereinafter
called VF) screen. Then, the four LEDs (AUDIO LED) on the right side of the camera will light up in
orange.
After the camera is powered on normally, the LEDs once turn off. Then, the color LCD on the right side
of the camera displays the logo "Ikegami" and the Status screen.
When a FieldPak2 (hereinafter called FP2) has been loaded in the camera, the logo "Ikegami" is displayed
and the disk is recognized automatically (recognition requires a few minutes).
For descriptions of each item displayed on the Status screen, refer to "Status Screen Display" (page 13)
in this "QUICK START GUIDE".
Turning OFF Power
Turn OFF the POWER switch to shut the power off.
A few seconds are required to complete the shutdown of the camera. When the camera is to be restarted,
the power must be turned ON 10 seconds or more after powering off.
CAUTION
Do not disconnect battery or turn off the power of the AC pack while the power of the camera remains
ON. This may cause damage of a clip (image and audio data).
G OU U
ON OFF
POWER
VF
CHARA
POWER Switch
DNS-33W 0503 VOL1 (E)
QUICK START GUIDE
DV25 PAL 48k
DVCPRO AIF
LOCAL
0
POWER 15.0V
FP1 02：43：49
FAT32
VID = CAMERA
1
READY
0001/0002
0003
00 : 02 : 06 :14
BIN FAG7CM 1M
(Status Screen)
1
2 3 4
NLT 1 .0 .9
DNS-33W