Ikegami Editcam 3 DNS-33W Operation Manual page 45

2.6.1 Displays in the Viewfinder
In addition to the LED indicators on the VF, marker and
character displays are also provided on the VF screen.
Details are provided below.
LED Indicators
WARN
!
R TALLY
Indicator
This lights when trouble has occurred.
WARN
This lights when the battery voltage has
BATT
fallen below the setting.
!
This lights when the settings are not the
standard (See Notice).
R TALLY
Lights during VTR recording (Red).
REMAIN
This lights when disk remaining is less
than set value.
Notice
For the default setting, the ! indicator lights in the
following settings.
Switch/Function
KNEE MODE
SKIN DTL
SHUTT/SUP-V
A. IRIS CORR
GAIN SELECT switch
AWB SELECT switch
LENS EXTENDER SELECT switch
FIELDPAK switch
Reference
• The value to output warnings can be set by the
menu of the recorder section. For details of the
setting, refer to "6.3.4 DISK SETTINGS Menu".
• Lighting conditions of the ! indicator can be set by
the camera menu. For details of the setting,
"5.10.6 ! INDICATOR (Selecting the warning
display items)".
R TALLY
BATT
REMAIN
Description
Setting
MANUAL
ON
ON
Other than OFF
Other than 0dB
OFF
ON
SAVE
DNS-33W 0503 VOL1 (E)
2. NAME AND FUNCTION
Center Marker, Safety Markers and Frame
Marker
• The Center Marker is used to ascertain the center of
the screen or align the camera horizontally and
vertically.
• The Safety Markers are used to check the action safety
area (90%) or title safety area (80%). Switching
between the action area and the title area is done by
the "SAFETY AREA" settings of the camera menu.
• The Frame Marker is used to ascertain the frame of the
image being shot.
• Aspect ratio (4:3/13:9/14:9/15:9/16:9) can be set to the
Safety Markers and Frame Marker.
Reference
Markers described above can be set by the camera
menu. For details of the setting, refer to "5.10.3 VF
DISPLAY (Selecting various status display modes on
the VF)".
Zebra Indicator
The zebra signals are striped patterns that appear
superimposed on the actual picture. There are two zebra
signals: the zebra 1 signal which appears in the area
where the video level of the subject is higher than the set
value, and the zebra 2 signal which appears only in the
area where the video level is the same as the set value.
The zebra indicator is turned ON or OFF using the
ZEBRA switch on the VF.
Reference
For details of the setting, refer to "5.10.5 ZEBRA
INDICATOR".
2 - 15
Center Marker
Title Area
Action Area
Frame Marker
DNS-33W