Fieldpak Switch; Nd Filter Knob; Gain Select Switch; Hyper Gain Switch - Ikegami Editcam 3 DNS-33W Operation Manual

22 FIELDPAK Switch

Used to turn ON/OFF the power of the hard disk motor
in an FP2.
Setting Value
STBY The hard disk is in the stand-by mode.
As the hard disk is turning, recording will start
right after pressing the REC button.
SAVE The hard disk is in the power saving mode.
As the hard disk is stopping, recording will start in
a few seconds after pressing the REC button.

23 GAIN SELECT Switch

Used to select the gain (sensitivity) of the camera.
As this switch is operated, the corresponding characters
appear on the VF.
Setting Value
Gain value equivalent to LOW setting in the
L
camera menu is obtained.
M
Gain value equivalent to MID setting in the
camera menu is obtained.
Gain value equivalent to HIGH setting in the
H
camera menu is obtained.

24 OUTPUT SELECT Switch

Used to switch the output signal of the camera.
Setting Value
The camera image is output.
CAM
The color-bar signal is output.
BARS

25 AWB SELECT Switch

Used to select a memory for Auto White Balance.
AWB settings can be stored in two memories, Ach and
Bch.
Setting Value
A Ach memory
Bch memory
B
OFF
Turns OFF White Balance adjustment. In this
position, the preset condition (3200K) is effective.

26 MONITOR AUDIO PAIR SELECT Switch

Used to select the pair of the audio channels (CH1/CH2, CH3/
CH4) for monitor output.
Description
Description
Description
Description
DNS-33W 0503 VOL1 (E)
2. NAME AND FUNCTION
27 MONITOR AUDIO CHANNEL SELECT
Switch
Used to change the audio channel output from the
speaker or earphone.
The MONITOR LEVEL knob adjusts the output level of
the audio channel that is currently selected by this switch.
By selecting MIX, CH1/CH2 or CH3/CH4 become
available for output simultaneously.

28 ND FILTER Knob

Used to select ND filter. The following four positions can
be selected.
Position
1
100% (CLEAR)
2
25% (1/4 ND)
3 6.25% (1/16 ND)
4 1.6% (1/64 ND)

29 HYPER GAIN Switch

Super high sensitivity gain of +30dB to +48dB is
obtained by pressing this switch. Characters are displayed
on the VF while this function is enabled.
The HYPER GAIN switch must be pressed and held for
2 seconds or more in order to prevent accidental
operation.

30 P.FUNC Switch

Used to turn ON/OFF the functions selected by user. User
can allocate the functions by pressing and holding this
button.

31 ECC FILTER SELECT Button

Used to adjust the ECC filter according to the color
temperature of the scene. The + button is used to increase
the color temperature, and the - button to decrease the
color temperature. The + and - buttons must be pressed
and held (for approximately 0.5 seconds or more) only
for the first time in order to prevent accidental operation.
Position
A
3200K
B
4300K
C 6300K
D 8000K
2 - 7
Setting Value
Setting Value
DNS-33W