Settings And Adjustment Of Camera; Microphone Power/Level Down Setting - Ikegami Editcam 3 DNS-33W Operation Manual

5.

SETTINGS AND ADJUSTMENT OF CAMERA

This chapter explains how to set and adjust various camera settings.

5.1 Microphone Power/Level Down Setting

GL IN
VIDEO
AUDIO
OUT
5.1.1 MIC POWER Switch
Depending on the type of microphone to use, switch the MIC
POWER switch.
Switch
Power is supplied by 48V phantom power.
P48
OFF
Stops the power supply.
Shoot at this switch position when using dynamic
microphones and microphones with built-in power
source.
Power is supplied by 12V AB powering.
AB12
Camera Left Side
PUSH
DNG Camera System
with Digital Disk Recorder
TC IN
TC
OUT
MIC POWER Switch
• P48 : 48V phantom power supply (For MC-15, MKH-416P48V, etc. )
• OFF : No power supply (For ATM-53/57)
• AB12 : 12V AB power supply (For MKH-416TU3, etc. )
MIC ATT Switch
• ON : Lowers the microphone output level by -20 dB (For MC-15, use this position. )
• OFF : No level down of microphone
Power Supply Type
DNS-33W 0503 VOL1 (E)
5. SETTINGS AND ADJUSTMENT OF CAMERA
MAINTE
P48
-20dB
OFF AB12
ATT POWER
MIC IN
PRESET
5.1.2 MIC ATT Switch
The output level of a microphone differs depending on the
type of microphone used. If the output level and the
sensitivity of the microphone are too high, turn "ON" the
MIC ATT switch to lower the level to -20 dB.
MIC POWER Switch
MIC ATT Switch
-20dB P48
OFF AB12
ATT POWER
MIC IN
PRESET
5 - 1
DNS-33W