Ikegami Editcam 3 DNS-33W Operation Manual page 119

6.2.2 VIDEO Menu
OUTPUT VIDEO
OUT
1
1 OUTPUT VIDEO
Moves to the "OUTPUT VIDEO" menu.
2 UP
Returns to the "AUDIO/VIDEO" menu.
Notice
When an external video signal is input, items
"INPUT VIDEO" and "CALIBRATION" are added to
the "VIDEO" menu. Normally, setting these items is
not necessary.
1 OUTPUT VIDEO Menu
SDI SOURCE :
a
TC
REC
a SDI SOURCE
Selects a signal input to the SDI part.
Input Signal
CAM
Video signal from the camera
REC
Video signal from the recorder section
This setting is valid when SDI option is attached.
b SCPHASE
Adjusts the phase of subcarrier.
Set the value between 127 and -128.
c GENLOCK
Selects a synchronization signal source.
Select "CAM".
d PB-HDLY
Adjusts the DELAY value of the horizontal direction
for the playback video signal.
Set the value between 80 and -80.
6. SETTINGS AND ADJUSTMENT OF RECORDER SECTION
UP
2
SCPHASE :
b
0
GENLOCK :
c
EXT
PB-HDLY :
d
0
UP
e
Description
DNS-33W 0503 VOL1 (E)
e UP
Returns to the "VIDEO" menu.
6.2.3 AUDIO Menu
TRACKS :
1
TC
4
METERS :
2
TC
LINEAR 1/3
1 TRACKS
Selects the number of audio channels (4, 2, or 0) to be
recorded on an FP2.
Data can be recorded effectively when this value is set
according to the number of channels for audio input to be
used. When "2" is set, only input to CH1 and CH2 will
be valid, and data of CH3 and CH4 are not recorded.
2 METERS
Switches the audio level meter, 3-level linear display or
6-level logarithmic display.
Display Type
Linear display LINEAR1/3, LINEAR2/3, LINEAR FULL
LOG 1/3 HI, LOG 2/3 HI, LOG FULL HI, LOG
Logarithmic
display 1/3 LO, LOG 2/3 LO, LOG FULL LO
3 HEADROOM
Sets a headroom value of the audio (0dBu to 24dBu).
Set this item to 20dB if there is no specific need to adjust
the setting. The factory setting is 20dB.
4 TONE FREQ
Sets a frequency of the test tone (100Hz to 4000Hz).
5 UP
Returns to the "AUDIO/VIDEO" menu.
6 - 3
HEADROOM :
3
14dB
TONE FREQ :
4
800hz
UP
5
Description
DNS-33W