Ikegami Editcam 3 DNS-33W Operation Manual page 135

7.2.6 Inspections when Using an External
Microphone
When an external microphone is used, check following items
before shooting and then connect the microphone.
Camera Left Side
MAINTE
-20dB
-20dB P48
OFF AB12
ATT POWER
MIC IN
PRESET
1. Before connecting the external microphone to the
microphone connector, set the MIC POWER switch and
MIC ATT switch according to the type of microphone
used.
[MIC POWER Switch Settings]
Setting Value
P48
For the microphone which requires 48V phantom
power supply. (Set to this position for a
microphone specific to DNS-33W.)
OFF For the microphone which requires no power supply
AB12 For the microphone which requires 12V AB power
supply
[MIC ATT Switch Settings]
Setting Value
ON
-20dB attenuation is introduced. (Set to this
position for a microphone specific to DNS-33W.)
OFF No attenuation is introduced.
2. Connect the microphone to the microphone connector.
7.3 P r e c a u t i o n s
Equipment is Used
This section explains precautions when each option is
attached to the camera.
P48
OFF AB12
ATT POWER
MIC IN
PRESET
MIC ATT Switch
MIC POWER Switch
Description
Description
w h e n O p t i o n a l
DNS-33W 0503 VOL1 (E)
7. TROUBLE SHOOTING AND MAINTENANCE
IEEE1394 Option
• Operations on all PCs with IEEE1394 terminal and
software are not guaranteed.
• Regardless of compression type selected in the recorder
section, a DV stream signal is always output from this
terminal.
• This terminal is only for DV stream output. DV stream
input is not supported.
• Time code information is not multiplexed.
• Among the 4 channels, audio signals are output to the 2
channels selected by the AUDIO OUTPUT switch.
• Audio-Video/Control protocol (AV/C) is not supported.
Playback and stop operations need to be done by the
camera.
SDI Output
SDI signal is output from VIDEO OUT connector when SDI
option is attached.
Audio embedded in an SDI signal is not supported.
Precautions for MSA-206V+MCA-400+MA-400
Operation
• For multicore cable operation, the maximum extension is
100m.
• When there is no need to record video or audio by the
camera, an FP2 must be removed when operating the
camera.
• When there is a need to record or play video or audio with
the camera, an FP2 must be attached to the camera.
• When the POWER of the camera is turned ON/OFF, an
FP2 must be removed from the camera.
When the POWER of the camera is turned ON/OFF
without removing the FP2, data stored in the FP2 may be
broken.
• By mounting the MSA-206V, an audio output connector
needs to be replaced by an interface connector with the
MCA-400. In this case, the 2-pin connector for lighting on
the handle cannot be used.
7 - 5
DNS-33W