Connecting A Microphone - Ikegami Editcam 3 DNS-33W Operation Manual

Removing and Attaching the Eyepiece
This section explains how to remove the eyepiece from the
VF.
1. Pull out the Eyepiece Release Lever and turn the eyepiece
to the direction of the arrow to unlock the eyepiece.
Pull
Eyepiece Release Lever
2. Remove the eyepiece.
[Attaching the eyepiece]
This section explains how to attach the eyepiece on the VF.
1. Insert the eyepiece as △ mark on the VF and △ mark on
the eyepiece aligns.
2. Turn the eyepiece to the direction of the arrow until it
clicks into position. When the eyepiece is locked, it
clicks.
mark

3.5 Connecting a Microphone

This section explains how to connect a microphone to the
camera.
3. INSTALLATION AND CONNECTION
3.5.1 Connecting a Front Microphone
1. Check that the microphone holder is attached to the VF.
If it is not attached, attach a microphone holder to the
microphone holder attaching mount. Various microphone holder
options are available depending on the size of the microphone.
2. Loosen the screw on the microphone holder to open it.
3. Put the microphone in the opened microphone holder and
tighten the screw to secure it in place.
Microphone Holder
Close
Open
Microphone
4. Set the microphone switch according to the type of
microphone used.
While the microphone is connected to the MIC connector
on the front of the camera, the microphone switch
operation cannot be performed.
5. Connect the microphone cable to the MIC connector on
the front of the camera, and insert the cable into the cable
clamp to remove any slack.
Insert the connector until it clicks into position. When the
connector is locked, it clicks.
MIC Connector
Reference
For the settings of the microphone switches, refer to
"5.1 Microphone Power/Level Down Setting".
DNS-33W 0503 VOL1 (E)
Screw
Camera Front Side
MAINTE
P48
-20dB
OFF AB12
ATT POWER
MIC IN
PRESET
3 - 7
Microphone
Cable
DNS-33W