Mounting The Lens - Ikegami Editcam 3 DNS-33W Operation Manual

8. Position the camera to the desired pan and tilt angles and
secure it.
Camera Right Side
Pan Lock
Tilt Brake
Loosen
Dismounting the Camera from a Tripod
This section explains how to dismount the camera on a
tripod.
1. Unlock the Camera by pressing the Red button on the
Lock lever when dismounting the Camera from a tripod.
Hold the Carrying Handle of the camera.
2. Lift the camera and then remove the wedge from the
tripod mount plate.

3.3 Mounting the Lens

This section explains how to mount the lens to the Camera.
Place the camera on a tripod or in a horizontal and stable
position to mount the lens. The lens mount of the camera
supports BTA standard.
1. Remove the lens cap by pushing up the lens lock lever.
2. Align and insert horizontally the pin of the lens into the
notch of the camera lens mount.
Firmly support the lens not to drop it.
3. Push down the Lens Lock Lever to secure the lens to the
camera.
4. Connect the Pigtail Cable to the Lens Connector, and the
Pigtail Cable is automatically locked by aligning and
pressing the connector pin to the lens connector.
Tilt Lock
Tripod
Pan Brake
0 1 2 3 4 5 6 7
Secure
DNS-33W 0503 VOL1 (E)
3. INSTALLATION AND CONNECTION
5. Fix the Pigtail Cable to the Cable Clamp to remove any
slack.
PEAKING CONTRAST BRIGHT ZEBRA TALLY
ON HIGH
OFF LOW
ON AWB
OFF ABB
SHUTT/SUP-V
MENU
AUDIO OUT VTR
Pigtail Cable
Lens Connector
CAUTION
Do not lift or hold the lens housing to support the
entire camera or carry the camera. An excessive
force applied to the lens mount will cause damage.
Dismount the Lens
This section explains how to dismount the lens from the
camera.
Place the camera on a tripod or in a horizontal and stable
position to dismount the lens.
1. Disconnect the Pigtail Cable from the Lens Connector.
Pulling the Pigtail Cable connector upward unlocks the
Pigtail Cable connector and disconnects it from the Lens
Connector.
2. Push down the Lens Lock Lever to remove the lens
horizontally from the camera lens mount.
3. Remove the Pigtail Cable from the Cable Clamp.
4. Place the lens cap to protect the lens from flaws.
Camera Front Side
Lens Lock Lever
Pin
Notch
DNS-33W
3 - 5