Camera Rear Side - Ikegami Editcam 3 DNS-33W Operation Manual

2.2 Camera Rear Side

This section explains the names and functions of the parts on the rear of the camera.
11
10
9
8
BACK TALLY Lamp
1
BACK TALLY Switch
2
3 AUDIO SELECT Switches
4 MIC ATT Switch
5 AUDIO OUT Connector
AUDIO IN CH1/CH2 Connectors
6
1 BACK TALLY Lamp
Lights up during recording to an FP2 to inform persons
behind the camera operator of recording. However, it does
not light up when the BACK TALLY switch is turned OFF.
2 BACK TALLY Switch
Used to turn ON/OFF the BACK TALLY lamp.
Setting Value
ON The BACK TALLY lamp lights up.
OFF The BACK TALLY lamp turns off.
3 AUDIO SELECT Switches
Used to select the audio signal.
Switches the audio signal as shown below depending on
the audio input.
Setting Value
When line-inputting the audio signal to the
LINE
AUDIO IN CH1/CH2 connectors.
MIC
When connecting a microphone to the AUDIO IN
CH1/CH2 connectors.
When connecting a microphone dedicated for
+48V ON
phantom powering to the AUDIO IN CH1/CH2
connectors.
MON
7
Description
Description
DNS-33W 0503 VOL1 (E)
2. NAME AND FUNCTION
1
2
LINE MIC
5
6
7
MON OUT Connector
8 DC IN Connector
9
PHONE Terminal
10
DC OUT Connector
11
CAMERA REMOTE Connector
4 MIC ATT Switch
Used to turn ON/OFF attenuation introduced into the
audio input from the AUDIO IN CH1/CH2 connectors.
Setting Value
Attenuation of approximately -20dB is introduced.
-20dB
OFF
Attenuation is not introduced.
5 AUDIO OUT Connector
Used for connecting audio equipment.
6 AUDIO IN CH1/CH2 Connectors
Used to input audio signals from a microphone or line.
7 MON OUT Connector
Connector used to output the video signal (ENC, Y, R, G,
B, R+G+B) set in the camera setting mode (menu) or by
the monitor screen.
During playback, the ENC signal of the playback images
is output.
8 DC IN Connector
Used to supply +12V DC power to the camera from the
connected AC pack.
3
+48V LINE MIC +48V
ATT
-20dB OFF
4
Description
2 - 3
DNS-33W