Ikegami Editcam 3 DNS-33W Operation Manual page 83

• Always press the memory card eject button to remove the
memory card from the slot. When the camera is powered
on, removing the memory card without pressing the
memory card eject button may damage the memory card
data and the memory card itself.
Important:
The camera does not allow a long file name
exceeding 8 characters and 3 filename extension
characters or a file name containing other than half-
size alphabets, such as Chinese characters,
Japanese characters "kana" etc. When saving the
camera data into the memory card which contains
files and folders with those file names, the data
inside the memory card may be destroyed, causing
a problem such as unable to access the data on the
memory card or unable to format the memory card
with the camera.
Notice
If an error occurs during loading/saving, various
error messages are displayed. The error messages
and their definitions are described in the following
table:
Error Message
CARD INSERT ERROR!
CARD ERROR!
ACCESS ERROR!
! DIFFERENT TYPE DATA
FILE ALREADY EXIST
FILE CREATE ERROR!
FILE DATA ERROR!
FILE NOT FOUND!
NOT SAVE DATA
FOR CAMERA
Notice
The round sticker attached to the memory card is
used for write protection. Applying the sticker in the
position shown in the next figure prevents formatting
the memory card or overwriting data on the existing
files by mistake.
Always use the sticker supplied with the card for
write protection. Do not touch, wet, etc. to keep the
applied sticker and the metal terminal clean.
5. SETTINGS AND ADJUSTMENT OF CAMERA
Definition
There is no memory card in the
slot.
The inserted memory card cannot
be used.
An error occurred during saving to
or loading from the memory card.
The specified data type is different.
There is already a file with the
same name.
The file could not be created.
There was an error in the data.
The file was not found on the
memory card.
The data on the memory card was
not saved by the camera.
DNS-33W 0503 VOL1 (E)
Memory Card
5.7.7 Formatting the Memory Card
This section explains how to format memory cards so that
they can be used for DNS-33W.
CAUTION
When a memory card is formatted, all the data
recorded on the card will be lost.
1. Select "FORMAT/DELETE".
MEMORY CARD
LOAD FILE
LOAD DATA
LOAD (→CAMERA )
SAVE FILE
SAVE DATA
SAVE (→M.CARD )
FORMAT/DELETE
M.CARD NAME
2. The following submenus are displayed. Select
"FORMAT" in detail items. "CANCEL" flashes in the
setting field. Rotate the rotary pulse switch and select
"EXECUTE", then press the SET button.
FORMAT
FORMAT
M.CARD TEST
DELETE FILE
DATA
DELETE
3. When the memory card is formatted, "COMPLETE" is
displayed on the screen.
5 - 9
Apply the sticker here
( )
SCENE1-8
( )
SCENE
( )
EXECUTE
( )
DNS-33W