Ikegami Editcam 3 DNS-33W Operation Manual page 69

7. Recording of a clip is started by pressing any one of the
REC button on the front of the camera, the REC button
on the handle, the VTR button on the lens, and the REC
key on the control switch panel.
VTR Button on
the Lens
SHIFT |<< >>|
IN ＜ ＞
OUT
<<< >>>
REC PLAY STOP
REC Key
Notice
• All keys on the control switch panel, except the
STOP key, are disabled during recording. If any
disabled key is pressed, message "Panel Locked"
appears on the screen.
DV25 PAL 48K
DVCPRO AIF
LOCAL
POWER 15.0V
FP1 02：43：24
FAT32
VID = CAMERA
RECORDING
Panel Locked
0001/0002
0003
00 : 02 : 11 : - - 0 : 04
BIN FAG7CM 1M
• When recording external input video, be sure to
press the REC key on the control switch panel.
• Even when "DISK" or "EXTERNAL" is selected for
"SWITCHER" of "AUDIO/VIDEO" menu of the
recorder section, pressing the REC button or the
VTR button on the lens automatically switches to
"CAMERA" and starts recording.
REC Button
The camera main body also
has REC button.
CH1 CH2 CH3 CH4
FRONT F F F
REAR R R R
W W W
WIRELESS
OUTPUT
AUTO CH1/2
MAN CH3/4
0
1 2 3 4
NLT 1 .0 .9
DNS-33W 0503 VOL1 (E)
8. To stop the recording, press the STOP key on the control
switch panel on the camera's right side, the REC button
on the camera's front side/carrying handle, or the VTR
button on the lens.
The REC/VTR button when pressed toggles between start
and stop of the recording.
Notice
Use the STOP key when stopping the recording of
external input video.
9. If you want to place the FP2 on standby after recording,
set the FIELDPAK switch on the right side of the camera
to "STBY". To place it in the power saving mode, set the
switch to "SAVE". Even with the FIELDPAK switch set
to "SAVE", you can take out the FP2 by pressing the
EJECT key on the top of the camera. For details of the
setting of retro-loop recording, refer to "6.4.1 RECORD
Menu".
CAUTION
Setting of date and time is required for recording it
on the clip. The factory-adjusted date and time will
be cleared if the backup battery in the recorder
section runs out of power. For details of the setting,
refer to "6.5.2 TIME&DATE Menu".
When Recording External Input Video
The following explains how to record external input images
and sound.
1. Connect the external VIDEO output line to the
GENLOCK IN connector on the left side of the camera.
2. Select the "A/V" (AUDIO/VIDEO) button on "BASE"
menu of the recorder section, and set "SWITCHER" to
"EXTERNAL".
3. Press the REC key on the control switch panel to start
recording.
4. Press the STOP key to halt the recording.
Notice
• The recording function of the external input video
is optional.
• If the REC button on the camera is pressed in this
state, the unit will record images from the camera.
4.9.2 Clip Playback
This section explains how to play a clip recorded on the FP2.
There are two ways to play clips, normal playback and REC-
REVIEW.
4. OPERATION
DNS-33W
4 - 9