Turning On Power; Power Supply From Ac Adapter; Power Supply From Bs - Ikegami HC-HD300 Operation Manual

4.3 Turning ON Power

4.3 Turning ON Power
The procedure for turning the power ON/OFF depends on how power is supplied to the camera. This section explains how to
supply power from an AC Adapter (External power) and the BS.

Power Supply from AC Adapter

Before turning the camera ON, make sure that the POWER switch on the AC Adapter is ON and the POWER indicator lights.
Reference:
Refer to "3. INSTALLATION and CONNECTION [Power Supply from AC Adapter]" (P49) for how to connect the camera to the
AC pack and how to turn the power ON.
1
Set the POWER switch on the camera to EXT.
Power will be supplied to the camera, and the POWER indicator will light in green.

Power Supply from BS

Before turning the camera ON, set the switches to the following positions in normal operations. The power is turned ON/OFF by
the MAIN POWER switch on the BS.
Camera POWER switch
BS BS MAIN POWER switch
HEAD POWER switch
OCP(*) CAM POWER switch
(*) When OCP-10 is used, the setting for the CAM POWER switch is not necessary.
1
Turn ON the MAIN POWER switch on the BS.
The BS checks the fiber cable connection and supplies power to the camera if the cable is properly connected. The CABLE
indicator on the BS will indicate the connection status of the fiber cable.
NORMAL (green) : Lights when the fiber cable is normally connected.
60
Switch
BS
OFF
I
ON
HC-HD300 1412 VER1 (U)
Switch Position