Ikegami Editcam 3 DNS-33W Operation Manual page 43

8 MIC POWER Switch
Used to select the type of power supplied to the
microphone connected to the MIC connector at the front
of camera.
Setting Value
P48 +48V Phantom power is supplied.
OFF
No power is supplied.
+12V AB power is supplied.
AB12
9 PRESET Button
Used to return the level adjustment and menu settings of
the camera to factory settings.
The button can only be pressed using a screwdriver with
a tapered tip.
10 MAINTENANCE Connector
Used only in factory. Do not connect anything usually.
11 MEMORY CARD Eject Button
This button is pressed to remove SmartMedia from the
MEMORY CARD slot.
12 MEMORY CARD Slot
Slot for SmartMedia that saves camera setting data.
13 TC IN Connector
Inputs the reference Time Code (TC) signal when time
code is desired to be externally locked.
14 TC OUT Connector
Accepts a cable connected to TC IN connector of external
equipment when time code of the external equipment is
desired to be locked with the camera.
Description
DNS-33W 0503 VOL1 (E)
2. NAME AND FUNCTION
15 GENLOCK IN Connector
Input the SYNC signal (black burst or composite signal)
from an external system to have the camera genlocked.
This connector is also used to input the video signal from
external equipment.
16 VIDEO OUT Connector
Outputs the video signal of the camera or color bar signal
in accordance with the OUTPUT SELECT switch position
(CAM/BARS) on the right side. In addition, the playback
images of the disk recorder section are automatically
output. SDI signal is output from VIDEO OUT connector
when SDI option is attached.
17 EMERGENCY EJECT Hole
Used to take out an FP2 by inserting a slotted screwdriver
etc. through this hole when an FP2 cannot be taken out
by pressing the EJECT key.
18 CONNECTOR LOCK Button
Used to prevent the VF connector from being released.
To remove the connector, press and hold the lock button.
19 VF Connector
Accepts the VF cable.
20 2-pin Connector for Lighting
Used to supply power (max. 50W) to a video light.
2 - 13
DNS-33W