Table of Contents
Advertisement
Chapter 3
INSTALLATION and
CONNECTION
3.1 Preparation
- - -
Operating environment
Please read "SAFETY PRECAUTIONS" described at
- - -
the beginning of this manual for precautions on use of this
product.
Make sure the Power Switch of AC
Adapter is OFF.
This product does not have a power switch. Be sure the Power
switch of AC Adapter is turned off before connecting this
product.
3.2 Mounting the
camera on the Tripod
Attach the camera to the tripod.
1
Align a tripod mounting hole of the camera to
Tripod mounting hole
Camera fixing screw
Caution
The camera has two types of mounting holes. Check the
screw size at the tripod side.
- Camera mounting screw (3/8-16UNC)
- Camera mounting screw (1/4-20UNC)
2
1
2
3
Bottom side
4
5
Tripod
UHL-43 2005 VER1 (E)
3 INSTALLATION and CONNECTION
Tighten the camera fixing screw to fix the
camera to the tripod.
3.3 Lens Attachment
Attach the lens to the camera.
When attaching the lens, place the camera on the tripod or on
a horizontal and stable surface.
Note
The lens mount of the camera supports the BTA mount
method.
Raise the lens lock lever to remove the lens
cap.
Align the lens pin and the notch of the camera
lens mount and insert horizontally.
At this time, hold with hand in order to prevent
dropping the lens.
Fix the lens to the camera.
camera.
2 Align and insert it into the notch.
Connect the pigtail cable to the lens connector.
When the pigtail cable is pressed in with the
connector pin aligned, it is automatically locked.
Note
Do not turn to lock or unlock.
Fix the pigtail cable to the cable clamp so it
does not get loose.
Caution
Avoid carrying the camera by holding the lens housing
only. Applying excessive force to the lens mount can cause
damage.
3 Push down the Lens lock
lever to secure the lens.
7
Advertisement
Table of Contents
