Creating An Isp Domain And Configuring Its Attributes - 3Com 4210 9-Port Configuration Manual

Creating an ISP Domain and Configuring Its Attributes

Table 2-3 Create an ISP domain and configure its attributes
Operation
Enter system view
Configure the form of the
delimiter between the user
name and the ISP domain
name
Create an ISP domain or set an
ISP domain as the default ISP
domain
Set the status of the ISP
domain
Set the maximum number of
access users that the ISP
domain can accommodate
Set the idle-cut function
Set the accounting-optional
switch
Set the messenger function
Set the self-service server
location function
Note that:
On an S4210 series switch, each access user belongs to an ISP domain. You can configure up to
16 ISP domains on the switch. When a user logs in, if no ISP domain name is carried in the user
name, the switch assumes that the user belongs to the default ISP domain.
Task
Cutting Down User Connections Forcibly
system-view
domain delimiter { at | dot }
domain { isp-name | default
{ disable | enable isp-name } }
state { active | block }
access-limit { disable |
enable max-user-number }
idle-cut { disable | enable
minute flow }
accounting optional
messenger time { enable limit
interval | disable }
self-service-url { disable |
enable url-string }
Optional
Command
2-2
Remarks
Remarks
—
Optional
By default, the delimiter
between the user name and the
ISP domain name is "@".
Required
If no ISP domain is set as the
default ISP domain, the ISP
domain "system" is used as the
default ISP domain.
Optional
By default, an ISP domain is in
the active state, that is, all the
users in the domain are allowed
to request network service.
Optional
By default, there is no limit on
the number of access users
that the ISP domain can
accommodate.
Optional
By default, the idle-cut function
is disabled.
Optional
By default, the
accounting-optional switch is
off.
Optional
By default, the messenger
function is disabled.
Optional
By default, the self-service
server location function is
disabled.