Ipv6 Telnet - 3Com 4210 9-Port Configuration Manual

Table 2-3 Download/upload files to TFTP servers
To do...
Download/ Upload files
from TFTP server
When you use the tftp ipv6 command to connect to the TFTP server, you must specify the "–i" keyword
if the destination address is a link-local address.

IPv6 Telnet

Telnet protocol belongs to application layer protocols of the TCP/IP protocol suite, and is used to
provide remote login and virtual terminals. The device can be used either as a Telnet client or a Telnet
server.
As the following figure shows, the Host is running Telnet client application of IPv6 to set up an IPv6
Telnet connection with Device A, which serves as the Telnet server. If Device A again connects to
Device B through Telnet, the Device A is the Telnet client and Device B is the Telnet server.
Figure 2-2 Provide Telnet services
Host
Telnet Client
Configuration prerequisites
Enable Telnet on the Telnet server and configure the authentication method. For details, refer to Login.
Table 2-4 Set up IPv6 Telnet connections
To do...
Perform the telnet command
on the Telnet client to log in to
other devices
When you use the telnet ipv6 command to connect to the Telnet server, you must specify the "–i"
keyword if the destination address is a link-local address.
tftp ipv6 remote-system [ -i
interface-type interface-number ] { get |
put } source-filename
[ destination-filename ]
Device A
Telnet Server Telnet Client
telnet ipv6 remote-system [ -i
interface-type interface-number ]
[ port-number ]
Use the command...
Device B
Telnet Server
Use the command...
2-3
Remarks
Required
Available in user view
Remarks
Required
Available in user view