3Com 4210 9-Port Configuration Manual page 763

Table 1-6 Configure a static neighbor entry
To do...
Enter system view
Configure a static
neighbor entry
Configure the maximum number of neighbors dynamically learned
The device can dynamically acquire the link-layer address of a neighbor node through NS and NA
messages and add it to the neighbor table. Too large a neighbor table may lead to the forwarding
performance degradation of the device. Therefore, you can restrict the size of the neighbor table by
setting the maximum number of neighbors that an interface can dynamically learn. When the number of
dynamically learned neighbors reaches the threshold, the interface will stop learning neighbor
information.
Table 1-7 Configure the maximum number of neighbors dynamically learned:
To do...
Enter system view
Enter VLAN interface view
Configure the maximum
number of neighbors
dynamically learned by an
interface
Configure the attempts to send an ns message for duplicate address detection
The device sends a neighbor solicitation (NS) message for duplicate address detection. If the device
does not receive a response within a specified time (set by the ipv6 nd ns retrans-timer command),
the device continues to send an NS message. If the device still does not receive a response after the
number of attempts to send an NS message reaches the maximum, the device judges the acquired
address is available.
Table 1-8 Configure the attempts to send an NS message for duplicate address detection
To do...
Enter system view
Enter VLAN interface view
Configure the attempts to send
an NS message for duplicate
address detection
Use the command...
system-view
ipv6 neighbor ipv6-address mac-address { vlan-id
port-type port-number | interface interface-type
interface-number }
Use the command...
system-view
interface interface-type
interface-number
ipv6 neighbors
max-learning-num number
Use the command...
system-view
interface interface-type
interface-number
ipv6 nd dad attempts value
1-11
Remarks
—
Required
Remarks
—
—
Optional
The default value is 2,048
Remarks
—
—
Optional
1 by default. When the value
argument is set to 0, the
duplicate address detection is
disabled.