Tcp Test (Tcpprivate Test) On The Specified Ports - 3Com 4210 9-Port Configuration Manual

# Start the test.
[Sysname-remote-ping-administrator-snmp] test-enable
# Display test results
[Sysname-remote-ping-administrator-snmp] display remote-ping results administrator snmp
remote-ping entry(admin administrator, tag snmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10
Min/Max/Average Round Trip Time: 9/11/10
Square-Sum of Round Trip Time: 983
Last complete test time: 2000-4-3 8:57:20.0
Extend result:
SD Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0
System busy operation number: 0
Operation sequence errors: 0
Other operation errors: 0
[Sysname-remote-ping-administrator-snmp] display remote-ping history administrator snmp
remote-ping entry(admin administrator, tag snmp) history record:
Index Response
1
2
3
4
5
6
7
8
9
10
For detailed output description, see the corresponding command manual.

TCP Test (Tcpprivate Test) on the Specified Ports

Network requirements
Both the remote-ping client and the remote-ping server are switches. Perform a remote-ping Tcpprivate
test to test time required to establish a TCP connection between this end (Switch A) and the specified
destination end (Switch B), with the port number set to 8000.
Network diagram
Figure 1-8 Network diagram for the Tcpprivate test
Status LastRC
10 1
10 1
10 1
10 1
9 1
11 1
10 1
10 1
10 1
10 1
1-33
Receive response times: 10
DS Maximal delay: 0
Operation timeout number: 0
Connection fail number: 0
Drop operation number: 0
Time
0 2000-04-03 08:57:20.0
0 2000-04-03 08:57:20.0
0 2000-04-03 08:57:20.0
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.8
0 2000-04-03 08:57:19.8