Setting To Output System Information To A Log Host; Setting To Output System Information To The Trap Buffer - 3Com 4210 9-Port Configuration Manual

Setting to Output System Information to a Log Host

Table 1-12 Set to output system information to a log host
Operation
Enter system view
Enable the information
center
Enable system information
output to a log host
Configure the source
interface through which log
information is sent to the log
host
Configure the output rules
of system information
Set the format of the time
stamp to be sent to the log
host
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.

Setting to Output System Information to the Trap Buffer

Table 1-13 Set to output system information to the trap buffer
Operation
Enter system view
Enable the information center
Command
system-view
info-center enable
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
info-center loghost source
interface-type interface-number
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp
loghost { date | no-year-date |
none }
Command
system-view
info-center enable
1-12
Description
—
Optional
Enabled by default.
Required
By default, the switch does not
output information to the log host.
After you configure the switch to
output information to the log host,
the switch uses information
channel 2 by default.
Optional
By default, no source interface is
configured, and the system
automatically selects an interface
as the source interface.
Optional
Refer to Table 1-8 for the default
output rules of system information.
Optional
By default, the time stamp format
of the information output to the log
host is date.
Description
—
Optional
Enabled by default.