3Com 4210 9-Port Configuration Manual page 300

Refer to AAA Operation Manual for detailed information about the dynamic VLAN delivery function.
Enabling 802.1x re-authentication
802.1x re-authentication is timer-triggered or packet-triggered. It re-authenticates users who have
passed authentication. With 802.1x re-authentication enabled, the switch can monitor the connection
status of users periodically. If the switch receives no re-authentication response from a user in a period
of time, it tears down the connection to the user. To connect to the switch again, the user needs to
initiate 802.1x authentication with the client software again.
When re-authenticating a user, a switch goes through the complete authentication process. It
transmits the username and password of the user to the server. The server may authenticate the
username and password, or, however, use re-authentication for only accounting and user
connection status checking and therefore does not authenticate the username and password any
more.
An authentication server running CAMS authenticates the username and password during
re-authentication of a user in the EAP authentication mode but does not in PAP or CHAP
authentication mode.
Figure 1-10 802.1x re-authentication
Internet
Switch
PC PC
802.1x re-authentication can be enabled in one of the following two ways:
The RADIUS server triggers the switch to perform 802.1x re-authentication of users. The RADIUS
server sends the switch an Access-Accept packet with the Termination-Action attribute field of 1.
Upon receiving the packet, the switch re-authenticates users periodically.
You enable 802.1x re-authentication on the switch. With 802.1x re-authentication enabled, the
switch re-authenticates users periodically.
RADIUS
Server
PC
1-11