Displaying Vlan Configuration; Configuring A Port-Based Vlan; Configuring An Access-Port-Based Vlan - 3Com 4210 9-Port Configuration Manual

The operation of enabling/disabling a VLAN's VLAN interface does not influence the physical
status of the Ethernet ports belonging to this VLAN.
An Switch S4210 can be configured with a single VLAN interface only, and the VLAN must be the
management VLAN. For details about the management VLAN, refer to the "Management VLAN
Configuration" part of this manual.

Displaying VLAN Configuration

To do...
Display the VLAN interface
information
Display the VLAN information

Configuring a Port-Based VLAN

Configuring an Access-Port-Based VLAN

There are two ways to configure Access-port-based VLAN: one way is to configure in VLAN view, the
other way is to configure in Ethernet port view.
Follow these steps to configure the Access-port-based VLAN in VLAN view:
To do...
Enter system view
Enter VLAN view
Add an Access port to
the current VLAN
Follow these steps to configure the Access-port-based VLAN in Ethernet port view:
To do...
Enter system view
Enter Ethernet port view
Configure the port link type as
Access
Use the command...
display interface Vlan-interface
[ vlan-id ]
display vlan [ vlan-id [ to vlan-id ] | all |
dynamic | static ]
Use the command...
system-view
vlan vlan-id
port interface-list
Use the command...
system-view
interface interface-type
interface-number
port link-type access
2-3
Available in any
view.
Remarks
—
Required
If the specified VLAN does not exist, this
command be created first creates the
VLAN before entering its view.
Required
By default, system will add all ports to
VLAN 1.
Remarks
—
—
Optional
The link type of a port is Access
by default.
Remarks