Displaying And Maintaining Cluster Configuration - 3Com 4210 9-Port Configuration Manual

A cluster is established, and you can manage the member devices through the management
device.
2) Configuration procedure
Perform the following operations on the management device to synchronize local user configurations:
To do...
Enter system view
Enter cluster view
Create a public local user
Perform the above operations on the management device of the cluster.
Creating a public local user is equal to executing these configurations on both the management
device and the member devices (refer to the AAA Operation part in this manual), and these
configurations will be saved to the configuration files of the management device and the member
devices.
The public local user configurations cannot be synchronized to the devices that are on the cluster
blacklist.
If a member device leaves the cluster, the public local user configurations will not be removed.

Displaying and Maintaining Cluster Configuration

Display all NDP configuration and running
information (including the interval to send
NDP packets, the holdtime, and all
neighbors discovered)
Display NDP configuration and running
information on specified ports (including
the neighbors discovered by NDP on the
ports)
Display global NTDP information
Display device information collected by
NTDP
Display status and statistics information
about the cluster
Display information about the candidate
devices of the cluster
Display information about the member
devices of the cluster
system-view
cluster
cluster-local-user username
passward { cipher | simple }
passwardstring
Operation
Use the command...
Command
display ndp
display ndp interface port-list
display ntdp
display ntdp device-list
[ verbose ]
display cluster
display cluster candidates
[ mac-address H-H-H |
verbose ]
display cluster members
[ member-number | verbose ]
1-22
Remarks
—
—
Required
Not configured by default.
Description
You can execute
the display
command in any
view.