Configuration Example - 3Com 4210 9-Port Configuration Manual

Configuration Example

Network requirements
For a user to manage Switch A remotely through Telnet, these requirements are to be met: Switch A has
an IP address, and the remote Telnet user is reachable.
You need to configure the switch as follows:
Assigning an IP address to the management VLAN interface on Switch A
Configuring the default route
Network diagram
Figure 1-1 Network diagram for management VLAN configuration
Console cable
RS-232 serial
interface
Current
user
Configuration procedure
Perform the following configurations after the current user logs in to Switch A through the Console port.
# Enter system view.
<SwitchA> system-view
# Create VLAN 10 and configure VLAN 10 as the management VLAN.
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] management-vlan 10
# Create the VLAN 10 interface and enter VLAN interface view.
[SwitchA] interface vlan-interface 10
# Configure the IP address of VLAN 10 interface as 1.1.1.1/24.
Switch A
Console port
Vlan- interface10
1.1.1.1/ 24
Ethernet1/1
1.1.1.2/ 24
Router
Telnet user
1-3