Console Port Login Configuration; Common Configuration - 3Com 4210 9-Port Configuration Manual

Figure 2-4 Set port parameters
3) Turn on the switch. You will be prompted to press the Enter key if the switch successfully
completes POST (power-on self test). The prompt appears after you press the Enter key.
4) You can then configure the switch or check the information about the switch by executing the
corresponding commands. You can also acquire help by typing the ? character. Refer to related
parts in this manual for information about the commands used for configuring the switch.

Console Port Login Configuration

Common Configuration

Table 2-2 Common configuration of console port login
Configuration
Console port
configuration
AUX user interface
configuration
Terminal
configuration
Optional
Baud rate
The default baud rate is 19,200 bps.
Optional
Check mode
By default, the check mode of the console port is set to
"none", which means no check bit.
Optional
Stop bits
The default stop bits of a console port is 1.
Optional
Data bits
The default data bits of a console port is 8.
Configure the
command level
Optional
available to the
By default, commands of level 3 are available to the
users logging in to
users logging in to the AUX user interface.
the AUX user
interface
Optional
Make terminal
By default, terminal services are available in all user
services available
interfaces
2-3
Remarks