3Com 4210 9-Port Configuration Manual page 663

Operation
Enable system information
output to the console
Configure the output rules
of system information
Set the format of time stamp
in the output information
To view the debugging information of some modules on the switch, you need to set the type of the
output information to debug when configuring the system information output rules, and use the
debugging command to enable debugging for the corresponding modules.
Table 1-8 Default output rules for different output directions
Output Modules
direction allowed
default (all
Console
modules)
Monitor default (all
terminal modules)
default (all
Log host
modules)
default (all
Trap buffer
modules)
default (all
Log buffer
modules)
default (all
SNMP NMS
modules)
Command
info-center console channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp { log |
trap | debugging } { boot |
date | none }
LOG
Enable
Severit Enabled/
d/disab
y disabled
led
Enable warning
Enabled
d s
Enable warning
Enabled
d s
Enable informati
Enabled
d onal
Disable informati
Enabled
d onal
Enable warning
Disabled
d s
Disable debuggi
Enabled
d ng
1-9
Description
Optional
By default, the switch uses
information channel 0 to output
log/debugging/trap information to
the console.
Optional
Refer to Table 1-8
output rules of system information.
Optional
By default, the time stamp format
of the log and trap output
information is date, and that of the
debugging output information is
boot.
TRAP
Enabled/
Severity
disabled
debuggin
Enabled
g
debuggin
Enabled
g
debuggin
Disabled
g
warnings Disabled
debuggin
Disabled
g
warnings Disabled
for the default
DEBUG
Severity
debuggin
g
debuggin
g
debuggin
g
debuggin
g
debuggin
g
debuggin
g