Configuring The 3C509B Nic - 3Com EtherLink III User Manual

Parallel tasking 16-bit isa network interface card

Hide thumbs Also See for EtherLink III:

Table of Contents

This chapter describes how to conﬁgure the 3C509B NIC,

reconﬁgure the NIC, and change conﬁguration settings.

Conﬁguring the 3C509B NIC

This section describes how to conﬁgure the 3C509B NIC.

If you have only one 3C509B NIC installed and you are

running Novell NetWare, use the AutoLink program to

conﬁgure the NIC and load the necessary driver, as

described in Chapter 3.

To conﬁgure the 3C509B NIC, follow these steps:

1 Install the NIC and network driver, as described in

Chapters 2 and 3.

2 Reboot your PC using a DOS diskette.

3 Put the EtherDisk diskette in ﬂoppy drive A.

4 To run the Install program, type:

a:install [Enter]

This opens the main menu shown in Figure 3-1.

5 From the main menu, select Conﬁguration and

Diagnostic Program.

If necessary, select the NIC you want to conﬁgure. Tab to

the Select button and press [Enter].

6 Select Conﬁgure NIC and press [Enter].

This opens the NIC Conﬁguration screen shown in

Figure 4-1.

ONFIGURING THE

3C509B NIC

Table of Contents

Troubleshooting

Do you have a question about the EtherLink III and is the answer not in the manual?