Qos Profile Configuration Example - 3Com 4210 9-Port Configuration Manual

Operation
configuration
Configuration Example

QoS Profile Configuration Example

Network requirements
All departments of a company are interconnected through a switch. The 802.1x protocol is used to
authenticate users and control their access to network resources. A user name is someone, and the
authentication password is hello. It is connected to Ethernet 1/0/1 of the switch and belongs to the
test.net domain.
It is required to configure a QoS profile to limit the rate of all the outbound IP packets of the user to 128
kbps and configuring to drop the packets exceeding the target packet rate.
Network diagram
Figure 2-1 Network diagram for QoS profile configuration
Network
Switch
Eth1/0/1
User
Configuration procedure
1) Configuration on the AAA server
# Configure the user authentication information and the matching relationship between the user name
and the QoS profile. Refer to the user manual of the AAA server for detailed configuration.
2) Configuration on the switch
# Configure IP addresses for the RADIUS server.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary authentication 10.11.1.1
[Sysname-radius-radius1] primary accounting 10.11.1.2
[Sysname-radius-radius1] secondary authentication 10.11.1.2
[Sysname-radius-radius1] secondary accounting 10.11.1.1
Command
profile-name | interface interface-type
interface-number | user user-name }
AAA Server
2-4
Description