Configuring Poe Over-Temperature Protection On The Switch; Upgrading The Pse Processing Software Online - 3Com 4210 9-Port Configuration Manual

Configuring PoE Over-Temperature Protection on the Switch

If this function is enabled, the switch disables the PoE feature on all ports when its internal temperature
exceeds 65°C (149°F) for self-protection, and restores the PoE feature settings on all its ports when the
temperature drops below 60°C (140°F).
Table 1-8 Configure PoE over-temperature protection on the switch
Operation
Enter system view
Enable PoE over-temperature
protection on the switch
When the internal temperature of the switch decreases from X (X>65°C, or X>149°F) to Y
(60°C≤Y<65°C, or 140°F≤Y<149°F), the switch still keeps the PoE function disabled on all the
ports.
When the internal temperature of the switch increases from X (X<60°C, or X<140°F) to Y
(60°C<Y≤65°C, or 140°F <Y≤149°F), the switch still keeps the PoE function enabled on all the
ports.

Upgrading the PSE Processing Software Online

The online upgrading of PSE processing software can update the processing software or repair the
software if it is damaged. Before performing the following configuration, download the PSE processing
software to the Flash of the switch.
Table 1-9 Upgrade PSE processing software online
Operation
Enter system view
Upgrade the PSE
processing software
online
Command
system-view
poe temperature-protection
enable
Command
system-view
poe update { refresh | full }
filename
1-6
Description
—
Optional
Enabled by default.
Description
—
Required
The specified PSE processing software
is a file with the extension .s19.