Table of Contents
Advertisement
3
Starting the Bridge Manager
Configuring the Bridge
This chapter describes how to add a 3Com Wireless Building-to-Building Bridge to your
wireless network using the Wireless Bridge Manager configuration utility.
The 3Com Wireless Building-to-Building Bridge Manager software communicates with
each wireless bridge using a non-routable protocol. Therefore, your wireless bridges must
be accessible on the local subnet to communicate with the Bridge Manager.
To run the Wireless Bridge Manager, follow these steps:
1 On the Windows taskbar, click Start.
2 Select Programs and then select the Program Group you created when you installed
the Wireless Bridge Manager (see "Installing the Wireless Bridge Manager Software"
on page 11).
3 Select the 3Com Wireless Bridge Manager entry.
The 3Com Wireless Building-to-Building Bridge Manager screen appears and the
Bridge Manager automatically scans the network for currently accessible bridge
groups. (See the next section,"Scanning for Bridge Groups," for more information
about bridge groups.)
13
Advertisement
Table of Contents
