Information Center Configuration; Introduction To The Information Center Configuration Tasks; Configuring Synchronous Information Output - 3Com 4210 9-Port Configuration Manual

Source
This field indicates the source of the information, such as the source IP address of the log sender. This
field is optional and is displayed only when the output destination is the log host.
Context
This field provides the content of the system information.

Information Center Configuration

Introduction to the Information Center Configuration Tasks

Table 1-4 Information center configuration tasks

Configuring Synchronous Information Output

Configuring to Display the Time Stamp with the UTC Time Zone
Setting to Output System Information to the Console
Setting to Output System Information to a Monitor Terminal
Setting to Output System Information to a Log Host
Setting to Output System Information to the Trap Buffer
Setting to Output System Information to the Log Buffer
Setting to Output System Information to the SNMP NMS
Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the system information such as log, trap, or
debugging information is output when the user is inputting commands, the command line prompt (in
command editing mode a prompt, or a [Y/N] string in interaction mode) and the input information are
echoed after the output.
This feature is used in the case that your input is interrupted by a large amount of system output. With
this feature enabled, the system echoes your previous input and you can continue your operations from
where you were stopped.
Table 1-5 Configure synchronous information output
Operation
Enter system view
Enable synchronous
information output
Task
Command
system-view
info-center synchronous
1-7
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Description
—
Required
Disabled by default