CLI Command Reference
logging host
This command enables logging to a host. You can configure up to eight hosts. The
the IP address of the logging host. The
can specify the
through one of the following keywords:
warning
Default
Format
Mode
logging host remove
This command disables logging to host. See
host indexes.
Format
Mode
logging port
This command sets the local port number of the LOG client for logging messages. The
<portid>
Default
Format
Mode
no logging port
This command resets the local logging port to the default.
Format
Mode
logging syslog
This command enables syslog logging. The
1-65535.
Default
Format
Mode
no logging syslog
This command disables syslog logging.
270
© 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
<severitylevel>
(4),
(5),
(6), or
notice
info
port—514
level—critical (2)
logging host <ipaddr> [<port>][<severitylevel>]
Global Config
logging host remove <hostindex>
Global Config
can be in the range from 1 to 65535.
514
logging port <portid>
Global Config
no logging port
Global Config
disabled
logging syslog [port <portid>]
Global Config
value is a port number from 1 to 65535. You
<port>
value as either an integer from 0 to 7 or symbolically
(0),
emergency
alert
(7).
debug
"show logging hosts"
parameter is an integer with a range of
<portid>
<ipaddr>
(1),
(2),
critical
error
on page 271 for a list of
is
(3),