Show Storm-Control; Port-Channel/Lag (802.3Ad) Commands - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
Format
Mode
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
NOTE:
Format
Mode

show storm-control

This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters. Use the
keyword to display the per-port configuration parameters for all interfaces, or specify the
slot/port
Format
Mode
Bcast Mode
Bcast Level
Mcast Mode
Mcast Level
Ucast Mode
Ucast Level

Port-Channel/LAG (802.3ad) Commands

This section describes the commands you use to configure port-channels, which are also
known as link aggregation groups (LAGs). Link aggregation allows you to combine multiple
full-duplex Ethernet links into a single logical link. Network devices treat the aggregation as if
it were a single link, which increases fault tolerance and provides load sharing. The LAG
feature initially load shares traffic based upon the source and destination MAC address.Assign
the port-channel (LAG) VLAN membership after you create a port-channel. If you do not
assign VLAN membership, the port-channel might become a member of the management
VLAN which can result in learning and switching issues.
A port-channel (LAG) interface can be either static or dynamic, but not both. All members of
a port channel must participate in the same protocols.) A static port-channel interface does not
require a partner system to be able to aggregate its member ports.
NOTE:
88 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
storm-control flowcontrol
Global Config
This command only applies to full-duplex mode ports.
no storm-control flowcontrol
Global Config
to display information about a specific interface.
show storm-control [all | <slot/port>]
Privileged EXEC
Shows whether the broadcast storm control mode is enabled or disabled.
The broadcast storm control level.
Shows whether the multicast storm control mode is enabled or disabled.
The multicast storm control level.
Shows whether the Unknown Unicast or DLF (Destination Lookup Failure)
storm control mode is enabled or disabled.
The Unknown Unicast or DLF (Destination Lookup Failure) storm control level.
If you configure the maximum number of dynamic port-channels (LAGs) that
your platform supports, additional port-channels that you configure are auto-
matically static.
all